I-1B Series Thick Slurry Pump （ Stainless Steel )/ Corrosion-Resistant Thick Slurry Pump

Specification

Theory Flow
PMPa (m3/h)

Flow
(m3/min)

Head
(m)

Suction Lift
(m)

Port Size

Speed
(r/min)

With Motor
(Kw)

Work pressure
(*Kg/cm2)

Model

I-1B1 inch

2.39

1.5

50

2

25

960

1.1

5

I-1B1.5 inches

5.2

3.2

80

3

40

960

2.2

8

I-1B2 inches

8.85

5.6

80

3

50

960

3

8

I-1B2.5 inches

10.6

6.5

60

3

65

960

3

6

I-1B3 inches

18.1

12

60

3

75

960

5.5

6

I-1B4 inches

24

16

60

3

100

960

7.5

6

I-1B5 inches

36

25

60

3

125

960

11

6

I-1B6 inches

38

30

60

3

150

960

15

6

Fault

reason

Troubleshooting

1. Start-up difficulties

1. The fluid is not full of pump cavities.

2. Filling caps are overstretched. There is too much friction rectangular between the axis and the filling.

1. Pumping of the main axle 3〜 with tube pliers; rotation 6

2. Adjustment of filling caps.

Post-commencement

No fluid.

1. Large air inhalation:

Electromagnetic Motion Uncorrected:   3.

1. Check if the intake fluid is too low.

2. Any two-way line for powering motors: & nbsp;

3. Rare-transmitting fluids.

3. Pumps with greater vibration or noise

1. An electrical motor is different from a pump axis:

2. Inhalation of large amounts of air within the pump or mixed with fluid -

Rearrangement of congener:

2 & nbsp;. Checking liquid levels. To remove air from inhalation fluids.

4. Significant decline in Flow during operation

1. Liner wear.

Speed reduction:

(c) Aerodynamic inactivation of aeroplanes;

& nbsp; 4. Inhalation pipe traffic fluids are not deep enough. Air piping pump ^

& nbsp;

2. Power and Motor: & nbsp;

3. Shut-down and overhaul. Change my axle or around it:

4. Extortion of small inhaled height.!

5. Overloading of electric motors

1. Head exceeding the pumping range by too many lengths:

2. Material viscosity is too high:

3. Voltage is too low.

1. Minimize the loss of piped water ... or replace the high Head pump.

Diluent fluids:

3. Reasons for inspection. Increase in Voltage to the required value & nbsp;

6. Large amount of leakage at axle seal fillings

1. Overstretching:

2. Filling wear and tear:

3. Enter Outlet position reverse.

1. Adjusting pressure caps: & nbsp;

2. Replacement of fillings:

Use the intermediate French mouth as the inhaler.